Good luck!! I'm rebuilding a MKI/II GT6 with a 72 Spitfire tub.
Ciao! - Jim M
--Previous Message--
: just a few things off the top of my head-
: engine-
: crank end float
: valve lift
: consider R&Ring the timing chain cover
: to check chain and tensioner.
: Bearing check?
:
: gearbox-
: check for trash in oil sample
: Remove top cover and check for
: excessive "wobble" of
: mainshaft gears, excessive end float,
: adequate clearance between
: "back" of sync rings/gears.
: You can also inspect the layshaft by
: removing front plate and tail housing,
: stand vertical, and slide the shaft out
: with a dummy shaft.
: HTH
: Glen
:
: --Previous Message--
: I have a GT6+ Engine and Tranny that I
: plan on putting in my 79 Spitfire this
: winter.
: What things can I check on the Engine
: and Tranny to make sure they are in
: good nick, before install them in the
: Spit. I don't want to take the engine
: apart unless I need to repair
: something.
: Engine: GT6+, 9.25:1, cylinder cold
: compression readings from #1 Aft,
: 145,175,165,155,155,170.
: Tranny: 4 Speed No OD.
: Thanks, Mike Mack
: 79 Spitfire
: 80 TR8
: 73 Stag
: 76 TR7
:
:
:
Responses