After reading this, I think it may be the music wire. I regarded that as an aligner only and was just making sure the tab and brush were aligned. Will try today.
Steve
--Previous Message--
: This is from memory so forgive any
: mistakes I make.
:
: The Triumph horn buttons have a little
: flat brass tag on the back/bottom that
: must be positioned to line up over the
: spring loaded brush. First make sure
: that the little "alignment
: nub" on your horn button is in the
: right position such that the brush and
: brass tab line up.
:
: On the bench make sure that when you
: push the horn button you get continuity
: between that formed music wire spring
: that sticks out the side and the brass
: tag. If you do not have continuity
: between these two parts when you press
: the button, something is wrong inside
: the horn button. If that is the case,
: you need to take the button apart again
: and see which internal connections are
: broken or corroded.
:
: If you have painted the wheel/hub,
: remember that the music wire spring on
: the side of the horn button must make
: good contact with the hole the switch
: is in. Scrape off any paint so you
: have good metal to metal contact.
:
: Doug L.
:
:
:
:
:
Responses