There might be some machining burrs on the splines that you could stone down or maybe try a bit of fine lapping compound. If you do lap it make sure it's perfectly clean before you assemble.
HTH
Glen
--Previous Message--
: 1/2 inner sync hub. Looks like could
: slide back and forth a bit when go from
: 1 to 2. Would take a small amount of
: slack on part of syncros , they would
: just float. Looks like the old was worn
: or intentionally made so it could slide
: back and forth a bit along with the
: syncro sleeve. New syncro hub is such a
: tight fit on the mainshaft it will stay
: where I put it. Centered between the
: split collars and the 2nd sipped gear?
:
: --Previous Message--
: Do you mean the 1/2 inner sync hub
: (splined) or the second gear bush?
: It doesn't really matter because they
: both need running clearance.
: HTH
: Glen
:
: --Previous Message--
: Next transmission question. Is the fit
: between the 1st/2ndsyncro sleeve and
: the mainshaft supposed to be a loose
: sliding fit or tight with the sleeve
: centered between the split collars and
: the 2 nd speed gear. The old worn
: sleeve was very worn and loose, the new
: is a tight fit and will not slide when
: in place along the mainshaft towards
: the 1st gear or towards the 2nd gear.
:
:
:
:
:
:
:
:
:
:
:
:
Responses