Posted by Josh on 9/21/2008, 8:29 pm, in reply to "Re: Replacement of rear transmission seal"
72.83.105.187
Nevermind...found it, as well as found that the nut on th back of the driveshaft was not torqued to spec. Used some seaelr on it and torqued to spec and hopefully no more leak!
--Previous Message--
: Thanks....the oil is coming out from
: between the two flanges (DS and
: tranny), rather than from the
: "forward" end of the flange
: assembly, so I think you're probably
: right. Will also check the breather
: hole...where is it?
:
: --Previous Message--
: Josh you should be able to tell when
: you
: unbolt the flange. If it's wet inside,
: it's most likely just getting by the
: splines. This condition is so common
: that BL put out a tech service bulletin
: on it because they were getting so many
: warranty claims on this.
: Obviously if it's dry, the seal and/or
: journal is at fault.
: Glen
:
: --Previous Message--
: Good tip glen, I'll try that first. I
: did
: pull the end seal to clean it up when I
: had the tranny out of the car, so
: perhaps I just didn't seal the
: nut/washer enough!
:
: --Previous Message--
: yes you can drop the shaft & pull
: the
: flange & get to the seal. It can be
: a PITA, of course. Also check the vent
: hole, make sure it's not plugged.
: Oil can also migrate along the splines
: & leak out around the nut &
: washer. A little dab of sealer under
: the washer will fix that.
: (A lot of perfectly good seals have
: been replaced whereas that has been the
: problem).
: HTH
: Glen
:
: --Previous Message--
: I'm getting a bit of leak from the rear
: transmission seal (where the trans
: attaches to the driveshaft). Can this
: be replaced without pulling the rear
: section of the tranny off the gearbox?
: E.g. can I just unbol the driveshaft
: and drop it out of the way, and press
: the bearing/collar off and do the seal
: without moving the tranny?
:
: of course I will drain the tranny
: too...too bad since it's full of new
: Redline MT-90...grr.
:
:
:
:
:
:
:
:
:
Responses: