Posted by Glen
on 9/20/2008, 10:26 am, in reply to "Replacement of rear transmission seal"
70.156.252.6
Here are several bulletins out of my archives.
I thought there was one addressing the spline/oil migration but I may be mistaken, but it is a very common problem.
--Previous Message--
: I'm getting a bit of leak from the rear
: transmission seal (where the trans
: attaches to the driveshaft). Can this
: be replaced without pulling the rear
: section of the tranny off the gearbox?
: E.g. can I just unbol the driveshaft
: and drop it out of the way, and press
: the bearing/collar off and do the seal
: without moving the tranny?
:
: of course I will drain the tranny
: too...too bad since it's full of new
: Redline MT-90...grr.
:
Responses: