Posted by Steve Downing on 5/6/2008, 10:11 am, in reply to "Re: Slicone valve cover gaskets are now available for Alloy covers!!!"
12.214.217.76
Yes! I should have a mold made for the Spit alloy cover in a day or two. I'll post here when I have some gaskets ready.
--Previous Message--
: Steve, Will you be making gaskets for
: Alloy Covers for a 1500 Spitfire? I
: have a nice leaky cork one on my 79
: Spit.
:
: --Previous Message--
: I finally have some gaskets ready for
: the
: Alloy valve cover for the TR6/GT6.
: These were patterned from an alloy
: cover so the radius of the corners
: matches the alloy cover, unlike the
: stock cork gaskets. It is a flat
: rectangular cross section that is a
: little wider and shorter than the stock
: cork gasket (5/16" wide by approx.
: 5/32" thick).
:
: Cost is $15 each. If you purchase
: direct from me I'll ship it free for US
: customers, reduced $3 shipping for
: international customers. If you choose
: this option just send your PayPal
: payment to me at downing1198@mchsi.com.
:
: Otherwise you can buy one off my ebay
: auction for TR6/GT6 Silicone gaskets
: for $15 plus $3 shipping(US customers)
: or $5.00 shipping for international
: customers. I will not have a separate
: listing for the alloy gasket, just
: purchase the one listed and note when
: you check out with PayPal that you want
: an alloy cover gasket. The link to
: this auction is below-
:
:
: http://cgi.ebay.com/ebaymotors/Triumph-TVR-TR6-GT6-TR250-Silicone-Valve-Cover-Gasket_W0QQcmdZViewItemQQcategoryZ10076QQihZ003QQitemZ130219405023QQrdZ1QQsspagenameZWDVW
:
: Thanks - Steve Downing
:
:
:
  |
|
Responses:
|