Posted by Josh on 4/22/2008, 7:25 pm, in reply to "Re: hub felt seal?"
71.246.252.15
That helps out with the concept, but is a bit confusing as to the install. I test-fitted and if they go the way they "seem" to be supposed to go, with the lip/edge against the bearing, they push the entire hub outward (??) Whereas when flipped with the rounded/beveled edge against the bearing, they fit fine but it seems to me that they wouldn't seal out much.
Besides the point that the D-washer is a bit too tight to get onto the threaded stud anyhow (dremel?)..
I'll make it easy. here are two sets of pics. Which one is correct, and which one wrong?
--Previous Message--
: Don't know if this is what you are
: looking for but ...
: http://mdmetric.com/prod/nilos/nilos3.htm
:
: --Previous Message--
: so not knowing what Nilos seals are
: apparently, got them in the mail today.
: So...expalain how these replace the
: felt seals? Do you pack them with
: grease or something. They look like
: nothing more than metal bushing pieces
: to me - I don't see how they seal
: anything.
:
:
  |
|
Responses:
|