Posted by Brian on 4/7/2008, 12:43 am, in reply to "Re: Wiper"
72.208.224.148
Did you check the voltage under load? Placing a draw on the wire may cause the voltage to drop significantly. If you have a voltage drop below... maybe 8V under load, then the problem may still lie with the wiring.
--Previous Message--
:
: Hi.
: Yes I checked the voltage and it is
: about 13 V. I also checked the cable
: that moves the wiper wheels and it all
: moves fine without the motor attached.
: Could it be that the motors I have are
: just shot.
:
  |
|
Responses:
|