Posted by phill
on 27/10/2009, 10:54 am, in reply to "Re: Cam Chain Tensioner Mod"
217.43.245.77
hi folks,this might seem like a daft question,if a manual one is fitted how exactly do you know how much tension to put on it,obviously you dont tighten it up like a bolt,would you just keep winding the spanner very gently until the last bit of slack has just and just gone.?
--Previous Message--
: Steve, for your info the cylinder head has to
: come off to replace that nylon wheel .
: Looks like I'll be cutting 10mm off the ZZR
: CCT spring when it all goes back together
: then, thanks for that info Pete.
:
: Phil
: Daan Saaf, innit.
:
: --Previous Message--
: Hi Pete whats a hill ,i don't think
: theres
: any of them here in Norfolk...
: On a more serious note i have been following
: the CCT issues on here and other Websites
: and have a Manual CCT sitting on the bench
: ready to be fitted over the winter, don't
: want the cam chain jumping just before i hit
: the majic 100.000 miles. Its just a simple
: locknut type jobbie similar to the APE one.
:
: Cheers Vulture
:
:
:
Message Thread:
« Back to thread