Posted by h2smokin
on 23/6/2009, 7:02 pm, in reply to "Camchain tensioner swap"
68.107.139.20
that's all I did when I swapped mine out. Just make sure the little pushrod? is in the fully retracted position. Then I just slowly slipped it in and snugged her down. It well set the tension automatically as you tighten everything up
--Previous Message--
: Hi there, I have finally got hold of a ZZR1100
: camchain tensioner to upgrade the standard
: one on my Z1300 - I now have a question for
: all you mechanical geniuses... Can I simply
: unbolt the old camchain tensioner and
: replace it with the ZZR tensioner or is
: there something else I need to do? I
: appreciate any help and advice you can give.
: Thanks... Paul T.
:
Message Thread:
« Back to thread