Posted by Hallen
on 11/5/2009, 12:26 am, in reply to "DFI Sensor"
62.20.210.120
Hi Ray...
And sorry...
Have you checked the valveplay?
Sounds as a common issue/fault on the DFI models.
The material in the inletvalves ar bad and gets in the end zero play....wich gives startingproblems...unfortunarly this i a common thing on the DFI-models...
Check out the valves and if you canīt adjust anymore you HAVE renovate the head/the valves.
Regards
Hallen
--Previous Message--
: Hi thanx for your feed back on two item's
: Firstly the DFI heat sensor i was having the
: DFI flashing on the dash area but i believe
: it was the connector that was lose i have
: put new connectors on and heat shrink so no
: flashing DFI light now, But hard to start
: and if i start it and let it cut out i
: cannot start it again plus it is running to
: rich and of course eratic due to carbon
: black plugs, secodly I have double checked
: the petrol tank conectors i will run an amp
: tester on the wires to see if there is
: current running on both sides of the fuel
: tank cable coneectors,
: Thanx all i do appreciate your kind advise.
: Regard's Ray 01603 610247
:
Message Thread:
« Back to thread