Posted by andy bentley
on 25/2/2009, 8:04 pm, in reply to "Re: zg1300a3 clutch side crank case"
86.2.90.239
cheers david, that very good of you!!! if you want to contact me on spenterrier@hotmail.co.uk then we can sort something out?
andy.
--Previous Message--
: I know you weren't Andy, I really did feel
: that I had stated the obvious - a bit of a
: Doh! moment.
:
: I wonder if you could use a slide hammer
: tapped into some of the casing bolt holes?
: The bolt holes would probably take an M8 tap
: 10mm deep or so if you can fix up a slide
: hammer with an M8 threaded end
:
: If it really doesn't come together I may
: have a casing but it isn't available yet and
: the lower left clutch adjuster cover bold
: hole is broken so you can only get 2 bolts
: in to the cover.
:
: I'm doing a hydraulic clutch conversion and
: I have a good casing that I intend to put on
: but this is a way off and I'm about to move
: house so don't want to start it prematurely.
:
: If you become really desperate I will swap
: them over for you so the old one is
: available for you.
:
: Regards
: David F
:
: --Previous Message--
: i was,nt being funny mate, i,m just very
: frustrated, oh well best thing to do is to
: look for another casing i suppose, anybody
: got one for sale???
:
: andy.
:
: <snipped>
:
Message Thread:
« Back to thread