[ Post a Response | THE BODYBUILDERS HOUSE OF INFO ]
Posted by Stan on 4/26/2005, 5:24 pm, in reply to "Re: Att: Paul" Thanks again --Previous Message--
Thanks Paul..Great advice. With the Parabolin will 3 shots a week be enough?100mg/ml? Doesn't Para burn fat? Would you recommend using some clen in the cutting part of this cycle?
Any idea the results I should get using this? I only wish I stated this cycle sooner, now being so close to summer.
To obtain 6000+ cal..I may need your help on a planned diet.
P.S. What's a boca burger? Soy product?
: Sounds like you want to get huge! You
: can up your deca to 750 also,and up
: your d-bol to 50.Then week 9-12 (4
: weeks only) keep the same cycle
: going and add the para.Week 13-17
: drop down to the winny and 400mg
: deca...ONLY.This is your best for
: cutting.Para is a heavy hitter and I
: dont like it as a cutter but its
: great for producing big muscles that
: are very dense and hard. Keep in
: mind that this is a very heavy
: cycle,so if you start feeling roid
: rage then cut back.Your diet looks
: good...eat the same way for both the
: bulking and the cutting...just eat
: as much of it as possible during the
: bulk and cut it way back during the
: cut cycle. Get some whey and soy
: protein powder and take in about 120
: grams of protein from whey and about
: 50 grams from soy. You can buy Boca
: burgers at the grocery and eat a
: double or triple patty sandwich for
: a meal.Your calories should be about
: 5-6000 during bulking and 2200
: during cutting.Be careful with this
: cycle dude.Its a heavy hitter. You
: will need more clomid too.Take 50mg
: X2 for one week after your last
: roid.So if you shoot a deca on
: saturday then the following saturday
: start the clomid. Then take a week
: off. Then go on the clomid again for
: 2 straight weeks. Be sure and use
: the nolva too.Its important for a
: cycle like this. I hate to give
: advice on these kind of cycles
: because these are the ones with the
: most side effects. Be cool and stay
: cool ok?
:
Message Thread:
« Back to thread